24X10X24X8 CD-RW/DVD, 40GB HD, and 1394/USB connector.
HD/adapter and pin 1 line up. Pin to be cut.
Cut HD pin. Notch and support for DVD drive
DVD drive prefit. Support notch.
More of the support notch.
DVD power connector trim. Power connector now fits near IDE cable.
Cut off one 1394 port. Ready for metal tape.
Shielded. Bracket altered to fit in case.
DVD - HD mounting bracket.
Don't cover hole. HD mounted.
Hole. Teflon tape under metal tape.
DVD mounted(had to cut screws down on this side). Placeholder screw.
Hard to get screw in place. Washers for spacing.
HD/DVD 1394/USB mounted. Bracket from old VCR.
Bracket altered, Tefloned, and screwed in place.
Bracket again. Exterior final.
The DVD/HD is held up by the notch on one side and a screw on the other.
And it is friction fit to the top of the NES case.